Wet dental trimmer 32-3/4

for orthodontics

An Orthodontic Angulator Attachment for precise grinding of angles onto plaster or stone models. Easily set to desired angle up to 120 degrees from mid-line in 5 degree increments. Produces precise angled models for sturdy presentation. For Handler 10” [25cm] or 12” [30cm] Model Trimmer. Orthodontic Angulator must be factory installed by Handler Weight1 lb [0.5 Kg] Dimensions5 1/4” x 5 1/4” [13cm x 13cm] Composition: Cast Iron INSPECTION Thank you for purchasing a Handler Model Trimmer. Unpackage your model trimmer. Check to make certain all accessories e.g., drain hose, inlet hose, model tray, etc. are properly packaged in the carton. Do not discard any portion of the packaging until all parts and accessories have been accounted for. Inspect the Model Trimmer. Should damage have occured in transit, contact the freight forwarder, immediately. Note on the shipping receipt any visible exterior damage to the shipping container. DO NOT contact Handler Manufacturing, as damage must be claimed by the receiver of merchandise-not the shipper. Failure to place a claim, promptly, may will negate your warranty and cause possible loss of your rights to place a claim for damage. GENERAL INSTRUCTIONS Your Handler Model Trimmer has been designed and built to provide years of service. Occasionally remove the electrical plug which is connected to the wall outlet and wipe the trimmer clean with a damp cloth. Remove any plaster and stone which may have become deposited on the trimmer’s surface.